Question Set

1. __________ metal is used as a bearing liner material.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->If a material; placed in a magnetic field is thrown out of it; then how is the material?....
QA->If a material, placed in a magnetic field is thrown out of it, then how is the material?....
QA->In which district; have large reserves of diamond-bearing kimberlite been discovered in the recent past?....
QA->In which district, have large reserves of diamond-bearing kimberlite been discovered in the recent past?....
MCQ->__________ metal is used as a bearing liner material.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2 L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will....
MCQ->When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be __________ the bearing modulus.....
MCQ->A clutch has outer and inner diameters 10 cm and 4 cm respectively.Assuming a uniform pressure of 2 x106 Pa and coefficient of friction of liner material is 4,the torque carrying capacity of the clutch is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution