A tube is specified by its ?->(Show Answer!)

Question Set

1. A tube is specified by its

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....

QA->Which is the planet its length of its day and the tilt of its axis are almost identical to those of the earth?....

QA->The process in which a liquid changes into its vapour from its surface at a temperature below its boiling point is called?....

QA->The length of a rectangular floor is 2 meters more than its width and its perimeter is 20 meters, then its area is....

QA->By which can the location and energy of an electron in an atom be specified?....

MCQ->In this section,each passage consists of 6 sentences.The first and sixth sentences are given in the beginning as S1 and S6.The middle four sentences in each are removed and jumbled up.These are labelled P,Q,R,S.You are required to find out the proper order of the sentences and mark accordingly on the answer sheet S1:At the roadside a driver will be asked to blow through a small glass tube into a plastic bag S6:The driver will be asked to go to the police station P:And if the color change did not reach the line the driver cannot be punished under the new law. Q:Inside the tube are chemically treated crystals which change color if the driver has alcohol on his brreath R:But if the color change did reach the line,then the test has proved positive S:If the color change goes beyond a certainline marked on the tube then this indicates the driver is probably over the specified limit The proper sequence should be....

MCQ->Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8").....

MCQ->A torsion member is fabricated from two concentric thin tubes. At the ends, the tubes are welded to rigid discs so that both the tubes are twisted as a unit. The radius of the outer tube is 2r and that of the inner tube is r. If the shear stresses developed in the outer tube is τ, then the shear stress in the inner tube will be.....

MCQ->Tube wall thickness depends on the cor-rosiveness of the fluids and their operating pressure & temperature and is specified by Birmingham wire gauge (B.W.G)-a number which varies from 8 to 18 with the numbers 14 and 16 being more commonly used. Outside diameter of tubes varies from about 15 to 50 mm; however a tube of less than __________ mm outside diameter is generally not recommended for fouling fluids.....

MCQ->Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution