Question Set

1. Solid angle subtended by the finite surface at the radiating element is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->If a liquid wets a solid surface; what is the angle of contact?....
QA->If a liquid wets a solid surface, what is the angle of contact?....
QA->A liquid will not wet the surface of solid if the angle of contact is?....
QA->Which element forms over 30 solid allotropes, more than any other element ?....
MCQ->Solid angle subtended by the finite surface at the radiating element is....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will....
MCQ->200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)....
MCQ->Consider the following statements : In solid waste management 1. density separation of solid wastes can be accomplished by air classifiers. 2. iron recovery from solid wastes can be done by magnetic separators. 3. aluminium separation from solid wastes can be accomplished by eddy current separators. Which of the statements given above are correct ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution