Question Set

1. The thermal radiative flux from a surface of emissivity = 0.4 is 22.68 kW/m2. The approximate surface temperature (K) is (Stefan-Boltzman constant = 5.67xl0-8 W/m2.K4)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->For a body moving with constant speed in a horizontal circle; what remains constant?....
QA->For a body moving with constant speed in a horizontal circle, what remains constant?....
QA->Which animals who have constant body temperature?....
QA->At constant temperature and pressure the voume of a gas is directly proportional to the number of molecule this law had been given by?....
QA->Flux reacts with the impurities to form fusible material. which is known as which name?....
MCQ->The thermal radiative flux from a surface of emissivity = 0.4 is 22.68 kW/m2. The approximate surface temperature (K) is (Stefan-Boltzman constant = 5.67xl0-8 W/m2.K4)....
MCQ->Two diffuse gray parallel plates,separated by distance,have surface temperatures of 1270C and 270If the emissivity of the surface are 8 and the Stefan-Boltzmann constant is 67 108W/m2K4,the net radiation heat exchanges rate in W/m2 between the two plates is:....
MCQ->Stefan-Boltzman law which describes the radiation heat transfer states that, it is proportional to (where, t = temperature in °C T = absolute temperature in ° K )....
MCQ->The Stefan-Boltzman constant depends on the....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution