Question Set

1. 'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->Which factor is not needed to calculate heat lost or gain when there is no change of state?....
QA->Which organization handed over to the Army the design of Mobile Metallic Ramp (MMR) for strategic mobility of armoured and mechanised units as well as formations of the Army?....
QA->.India"s First and only Design University?....
QA->What is the Mode of transmission of heat in which heat carried by a moving particles?....
MCQ->'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a....
MCQ->Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is....
MCQ->For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it....
MCQ->Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat. Heat transfer co-efficient for the cooling water, whether on shell side or tube side is the same. The best arrangement is....
MCQ->In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution