Question Set

1. For a multipass shell and tube heat exchanger, the LMTD correction factor is always





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->Which factor is not needed to calculate heat lost or gain when there is no change of state?....
QA->Bagley correction is done to account for....
QA->In proofreading an instruction that countermands a previously marked correction....
QA->What is the Mode of transmission of heat in which heat carried by a moving particles?....
MCQ->For a multipass shell and tube heat exchanger, the LMTD correction factor is always....
MCQ->Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is....
MCQ->LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is....
MCQ->It is not recommended to use a 1-2 shell and tube heat exchanger for a particular heat duty, whenever the LMTD correction factor is....
MCQ->For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution