1. The heat treatment process applied to cold formed steel parts is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
QA->Growth movements in response to the stimulus of heat or cold is called?....
QA->The transfer of heat between different parts of the body or from one body to another in contact with it is called?....
QA->What is the Mode of transmission of heat in which heat carried by a moving particles?....
MCQ->Consider the following statements in regard to aerobic and anaerobic treatment processes : 1. Biomass production in the aerobic treatment process is more as compared to the anaerobic treatment process. 2. Start-up period is more in the aerobic treatment process as compared to the anaerobic treatment process. 3. Energy consumption and production is more in the aerobic treatment process as compared to the anaerobic treatment process. Which of the statements given above is/are correct ?....
MCQ->The heat treatment process applied to cold formed steel parts is....
MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....
MCQ->The heat treatment process to which castings and the steel balls produced by cold heading are subjected is....
MCQ->A mild steel bar is in three parts, each 20 cm long. The diameters of parts AB, BC and CD are 2 cm, 1 cm and 3 cm respectively. The bar is subjected to an axial pull of 4t as shown in the given figure. If E = 2 x 106 kg/cm2 and the elongations in the three parts of the bar are Δ1, Δ2 and Δ3 respectively, then the ratio of the greatest to the least of these elongations will be

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution