Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Multiple Choice Question in 035/2016
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
chemical engineering nuclear power engineering
1. A control rod
(A): both (b) and (c).
(B): is generally made of boron, hafnium or cadmium.
(C): should have large absorption cross-section.
(D): should have small absorption cross-section.
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The real control of the Indian Government was passed into the hands of the President of Board of Control by passing the?....
QA->Which of the following is not a quantitative credit control weapon used by RBI to control credit....
QA->When an ebonite rod is rubbed with fur; which charge acquired by the fur?....
QA->When an ebonite rod is rubbed with fur, which charge acquired by the fur?....
QA->Kiss the rod....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....
MCQ->A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is....
MCQ->A steel rod, 100 mm long is held between two rigid supports. It is heated by 20°C. If the coefficient of thermal expansion of the material of the rod is 15 x 10-6 /° C and modulus of elasticity is 200 x 103 MN/m2, what is the stress in the rod ?....
MCQ->A rod shown in the given figure is such that the lower part is made of steel and the upper part is made of copper. Both the ends of the rod are rigidly clamped. If an axial force P is applied at the junction of the two metals, given that the ratio Esteel/ECopper is equal to 2, then the force in the copper rod would be ....
MCQ->A horizontal rod AB carries three loads of 3.0 kg, 7.0 kg and 10.0 kg at distances of 2.0 cm, 9.0 cm and 15 cm respectively from A where it is hinged. Neglecting the weight of the rod, which is the point at which the rod will be balance ?....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution