Question Set

1. A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Read the statements carefully and answer the question which follow: A cube has six sides each of a different colour.The red side is opposite black.The green side is between red and black.The blue side is adjacent to white .The brown side is adjacent to blue.The red side is face down.The side opposite brown is:....
QA->A train having a length of 240 metre passes a post in 24 seconds. How long will it take to pass a platform having a length of 650 metre?....
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is....
QA->A ship 55 km from the shore springs a leak which admits 2 tonnes of water in 6 minutes, 80 tonnes would suffice to sink her, but the pumps can throw out 12 tonnes an hour. The average rate of sailing that she may just reach the shore as she begins to sink is:....
QA->A train 110ms long passes a telegraph pole in 3 seconds. How long will it take to cross railway platform 165 ms long....
MCQ->A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm2, the side of the rod, is....
MCQ->ABC is rigid bar. It is hinged at A and suspended at B and C by two wires BD and CE made of copper and steel respectively, as shown in the given figure. The bar carries load of 1t at F, mid-way between B and C. Given Ac = 4 cm2, A = 2 cm2, Ec = 1 x 106 kg/cm2, Es = 2 x 106 kg/cm2. Ps is the force in the steel wire and Pc is the force in the copper wire, the ratio Pc/Ps will be

....
MCQ->The section modulus of a rectangular light beam 25 metres long is 12.500 cm3. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is....
MCQ->At a cross-section of a beam, the maximum compressive stress at top is 800 kg/cm2 and its maximum tensile stress at bottom is 200 kg/cm2. The depth of cross-section is 10 cm. The depth of the neutral axis from the top of the section is n. The n is equal to....
MCQ->A steel rod of sectional area 250 sq. mm connects two parallel walls 5 m apart. The nuts at the ends were tightened when the rod was heated to 100°C. If αsteel = 0.000012/C°, Esteel = 0.2 MN/mm2, the tensile force developed at a temperature of 50°C, is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution