Question Set

1. Which of the following thermocouples will give the highest output for the same value of hot and cold junction temperature ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->On a cold day when a room temperature is 15oC, the metallic cap of a pen becomes much colder than its plastic body, though both are at the same temperature of 15oC, because?....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->A temperature at which both the Fahrenheit and the centigrade scales have the same value?....
QA->Which element on adding to natural rubber makes it less sticky in hot weather and less hard in cold weather?....
QA->Which is the highest grade of coal whose surface is shining and has the highest calorific value?....
MCQ->Which of the following thermocouples will give the highest output for the same value of hot and cold junction temperature ?....
MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....
MCQ->The calibration data of a thermocouple with its cold junction at 0°C are given below. The hot junction of the thermocouple is placed in a bath at 80°C, while its cold junction is at 20°C. What is the emf of thermocouple ?....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->In a parallel flow heat exchanger, if the outlet temperature of hot and cold fluids are the same, then the log mean temperature difference (LMTD) is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution