Question Set

1. Upper portion of hot metal mixer are lined with mullite bricks, which helps in resisting the





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The king of Travancore issued a proclamation announcing the right of Nadar women to wear upper clothes but on condition that they should not imitate the style of clothing worn by upper class women?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Who were the inventors of concrete and the technique of binding stone and bricks?....
QA->What is known as the bricks of Universe?....
QA->What is the chemical name of Witherite, compound used in rat poison, bricks and cement ?....
MCQ->Upper portion of hot metal mixer are lined with mullite bricks, which helps in resisting the....
MCQ->Lower part of hot metal mixer are lined with __________ bricks.....
MCQ->Statements: Some bricks are trees. All trees are pens. All pens are boats. Conclusions: Some boats are bricks. Some pens are bricks. Some trees are bricks. Some bricks are boats.

....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->For ornamental work, which type(s) of bricks is/ are preferred ? 1. Silica bricks 2. Silica lime bricks 3. Bricks produced in autoclaves Select the correct answer using the code given below :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution