Question Set

1. In flat roof of reinforced cement concrete, the recommended angle of slope, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->Which type of glass is used for making glass reinforced plastic?....
MCQ->In flat roof of reinforced cement concrete, the recommended angle of slope, is....
MCQ->Which of the statements regarding to Portland Cement are correct? 1.Silica imparts strength to cement 2.Alumina makes cement quick setting 3.Excess of lime increases strength of cement 4.Calcium sulphate decreases initial setting time of cement Select the correct answer using the code below....
MCQ->Consider the following statements : For an over-reinforced (singly reinforced) rectangular RC section. 1. the lever arm will be less than that for a balanced section. 2. the maximum stress developed by steel would equal the allowable stress in steel. 3. the maximum stress developed by concrete would equal allowable stress in concrete. Of these statements :....
MCQ->Which among the following assumptions are made in the design roof trusses ? 1. Roof truss is restrained by the reactions 2. Axes of the members meeting at a joint intersect at a common point 3. Riveted joints act as frictionless hinges 4. Loads act normal to roof surface Select the correct answer using the codes given below:....
MCQ->A 40° slope is excavated to a depth of 10 m in a deep layer of saturated clay of unit weight 20 kN.m3; the relevant shear strength parameters are cu = 70 kN/m2 and φu = 0. The rock ledge is at a great depth. The Taylor's stability coefficient for φu = 0 and 40° slope angle is 0.18. The factor of safety of the slope is :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution