Question Set

1. If an element of a stressed body is in a state of pure shear with a magnitude of 80 N/mm2 , the magnitude of maximum principal stress at that location is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Pure water is a bad conductor of electricity because pure water does not dissociate into?....
QA->In a certain code, "FOP" stands for "OLD IS GOLD", POT stands for "GOLD IS PURE" and POM stands for GOLD IS COSTLY. Then how will "PURE OLD GOLD IS COSTLY" be written?....
QA->By whom were the triratnas were stressed?....
QA->Which element is present in maximum amount in human body?....
QA->Which is the principal element used in the production of solar cell?....
MCQ->If an element of a stressed body is in a state of pure shear with a magnitude of 80 N/mm2 , the magnitude of maximum principal stress at that location is....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
MCQ->Consider the following statements : In a uni-dimensional stress system, the principal plane is defined as one on which the 1. shear stress is zero. 2. normal stress is zero. 3. shear stress is maximum. 4. normal stress is maximum. Of these statements :....
MCQ->Consider the following statements : If two planes at right angles carry only shear stress of magnitude 'q', then the 1. diameter of Mohr's circle would equal 2q 2. centre of the Mohr's circle would lie at the origin 3. principal stresses are unlike and have magnitude 'q' 4. angle between the principal plane and the plane of maximum shear would be equal to 45° Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution