Question Set

1. Following gases are used in Tungsten inert gas Welding:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which gases are used for gas welding?....
QA->The gases used in different types of welding would include?....
QA->The inert gas which is substituted for nitrogen in the air used by deep sea divers for breathing, is?....
QA->Who is the inventor of Inert Gases (Argon; Neon; Helium etc)?....
QA->The inert gases are ____ in water?....
MCQ->Following gases are used in Tungsten inert gas Welding:....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In tungsten-inert gas arc welding, a __________ electrode is used.....
MCQ->The relation among various mass transfer co-efficients (M.T.C) for ideal gases is given by (where, Kc & Km are M.T.C. for equimolar counter diffusion with concentration & mole fraction respectively as the driving force. and, Kp = M.T.C. for diffusion of a gas through a stagnant inert gas with pressure as driving force.)....
MCQ->Projection welding & stud welding is categorised as the __________ welding.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution