Question Set

1. If D is the diameter of a pipe of length L and f is the coefficient of friction of pipe then diameter of the nozzle d is


Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->The ratio of length and breadth of a rectangle is 7: if perimeter is 52 then, what is the length of the rectangle?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->Arjun walks 20 m towards North. Then he turns right and walks 30 ms. Again he turns right and walks 35 ms. Then he turns left and walk 15 ms. How far and in which direction Arjun now from his starting point?....
MCQ->If D is the diameter of a pipe of length L and f is the coefficient of friction of pipe then diameter of the nozzle d is....
MCQ->A nozzle is fitted at the end of a pipe whose length is 320 m and diameter is 10 cm. If the value of f = 0.01, the diameter of the nozzle for the maximum transmission of power through the nozzle is....
MCQ->The velocity of steam leaving the nozzle (V) is given by (where K = Nozzle coefficient or nozzle efficiency, and hd = Enthalpy or heat drop during expansion of steam in a nozzle)....
MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....
MCQ->A nozzle is said to be a convergent-divergent nozzle, when the cross-section of a nozzle first decreases from its entrance to throat and then increases from its throat to exit.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution