Question Set

1. The length of pipe is L, velocity of flow of a liquid in the pipe is V. If t is the time in second required to close the valve, the head of pressure


Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Of the four locations mentioned below the highest inside temperature will be attained in the pressure cooker operated with the pressure valve open?....
QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....
QA->The length of an Earth day is determined by the time required for approximately one?....
QA->An electric train having 120 m. length is running at a speed of 90 km/hour. Find the time required for the train to cross a bridge of 630 m. long :....
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
MCQ->The length of pipe is L, velocity of flow of a liquid in the pipe is V. If t is the time in second required to close the valve, the head of pressure....
MCQ->The following statements relate to a laminar flow : 1. Laminar flow is rotational. 2. In laminar flow the loss of head is proportional to the square of the velocity. 3. In laminar flow the loss of head is proportional to the first power of viscosity. 4. In laminar flow the velocity is constant over the cross-section. 5. Other quantities remaining the same, increase in diameter will increase the Reynolds number in laminar flow. Of these statements :....
MCQ->A 2" gate valve fitted in a pipe is replaced by a similar globe valve. Pressure drop in gate valve was Δp. For the same discharge, the pressure drop across globe valve is....
MCQ->A tank is filled by three pipes with uniform flow. The first two pipes operating simultaneously fill the tank in the same time during which the tank is filled by the third pipe alone. The second pipe fills the tank 5 hours faster than the first pipe and 4 hours slower than the third pipe. The time required by the first pipe is:....
MCQ->The time required to close a valve gradually is (where L is the length of pipe and C = velocity of pressure wave)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution