Question Set

1. If depth of slab is 10 cm, width of web 30 cm, depth of web 50 cm, centre to centre distance of beams 3 m, effective span of beams 6 m, the effective flange width of the beam, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In which temple Sree Narayana Guru Installed a slab as idol with the words, “Sathyam’ (Truth), Dharmam (Ethics), Daya (Compassion), Sneham (love)”?....
QA->A _____ is a computer attached to the internet that runs a special web server software and can send web pages out to the other computer over the internet.....
QA->An IT term refers to allowing someone to open web pages and see web sites on the internet.....
QA->Which of the following identifies a specific web page and its computer on the web?....
QA->Which of the following identifies a specific web page and its computer on the Web ?....
MCQ->If depth of slab is 10 cm, width of web 30 cm, depth of web 50 cm, centre to centre distance of beams 3 m, effective span of beams 6 m, the effective flange width of the beam, is....
MCQ->A T-beam roof section has the following particulars : Thickness of slab 100 mm Width of rib 300 mm Depth of beam 500 mm Centre to centre distance of beams 3.0 m Effective span of beams 6.0 m Distance between points of contraflexure is 3.60 m. The effective width of flange of the beam is....
MCQ->The following quantities refer to a channel section used as a beam : b = width of flange (upto centre of web thickness). h = depth of web (c/c of flange thickness). t = thickness of flange and web. I = moment of inertia of channel about xx axis. e = distance of shear centre, outside the channel from the mid thickness of the web. The value of 'e' is given by....
MCQ->A simply supported beam of span L carries a concentrated load W at its mid-span. If the width 'b' of the beam is constant throughout the span, then, when the permissible bending stress is 'f', the beam's mid-span depth will be....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution