Question Set

1. When a tension member consists of two channel sections, the allowance for rivet hole is made for two holes from






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.....is a device by virtue of which two persons at two different places can communicate. It consists of two main parts (i) a microphone and (ii) a receiver.?....
QA->A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->A metal sheet with a circular hole is heated. The hole will?....
MCQ->When a tension member consists of two channel sections, the allowance for rivet hole is made for two holes from....
MCQ->The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called....
MCQ->When a tension member is made of four angles with a plate as a web, the allowance for holes is made as....
MCQ->In a tension member if one or more than one rivet holes are off the line, the failure of the member depends upon :....
MCQ->In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution