Question Set

1. Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300 mm or





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->When a proclamation of national emergency is in force, the term of Lok Sabha can be extended by Parliament for the first time for a period not exceeding ...... at a time?....
QA->Which element on adding to natural rubber makes it less sticky in hot weather and less hard in cold weather?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->Name the first warship built with iron plates?....
MCQ->Tacking rivets in compression plates not exposed to the weather, have a pitch not exceeding 300 mm or....
MCQ->When plates are exposed to weather, tacking rivets are provided at a pitch in line not exceeding (where t is the thickness of the outside plate).....
MCQ->Tacking rivets in tension members, are provided at a pitch in line not exceeding....
MCQ->S1: This weather-vane often tops a church spire, tower or high building. P : They are only wind-vanes. Q : Neither alone can tell us what the weather will be. R : They are designed to point to direction from which the wind is coming. S : Just as the barometer only tells us the pressure of air, the weather-vane tells us the direction of wind. S6: The weather-vane can, however give us some indication of other. The Proper sequence should be:....
MCQ->Two steel plates each of width 150 mm and thickness 10 mm are connected with three 20 mm diameter rivets placed in a zig-zag pattern. The pitch of the rivets is 75 mm and gauge is 60 mm. If the allowable tensile stress is 150 MPa, the maximum tensile force that the joint can withstand is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution