Question Set

1. A fillet weld whose axis is parallel to the direction of the applied load, is known as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A man is facing South. He turns 1350 in the anti clockwise direction and then 1800 in the clockwise direction. Which direction is he facing?....
QA->What is a graph is plotted taking °C along the Y-axis and of K along the X-axis?....
QA->If a graph is plotted taking the temperature in Fahrenheit along the Y-axis and the corresponding temperature in Celsius along X- axis it will be the straight line?....
QA->Particles vibrate parallel to the direction of propagation of wave in?....
QA->A wave motion in which the particles of the medium vibrate parallel to the direction of propagation of wave is?....
MCQ->The permissible stress in the fillet weld is 100 N/mm2. The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is....
MCQ->A fillet weld whose axis is parallel to the direction of the applied load, is known as....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)....
MCQ->A circular plate 100 mm diameter is welded to another plate by means of 6 mm fillet weld. If the permissible shearing stress in the weld equals 10 kg/mm2, then the greatest twisting moment that can be resisted by the weld will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution