Question Set

1. The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.The most effective air cleaner in case of diesel engine is:....
QA->Which fort was called “like a pistol held at the Zamorin’s throat”?....
QA->A civil case becomes a fit case for appeal to the Supreme Court if:?....
QA->Which rays can pass through 20 cm thickness of steel?....
QA->An infectious disease in back of the throat.....
MCQ->The size of a butt weld is specified by the effective throat thickness which in the case of incomplete penetration, is taken as....
MCQ->What will be the output of the C#.NET code snippet given below? char ch = Convert.ToChar ('a' | 'b' | 'c'); switch (ch) { case 'A': case 'a': Console.WriteLine ("case A | case a"); break; case 'B': case 'b': Console.WriteLine ("case B | case b"); break; case 'C': case 'c': case 'D': case 'd': Console.WriteLine ("case D | case d"); break; }....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In a butt welded joint, the size of weld is __________ the throat of weld.....
MCQ->The effective throat thickness in mm of a 6 mm size fillet weld with an angle of 75° between the fusion faces is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution