Question Set

1. Working shear stress on the gross area of a rivet as recommended by Indian Standards, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A can complete a work in 12 days with a working of 8 hours per day. B can complete the same work in 8 days when working 10 hours a day. If A and B work together, working 8 hours a day, the work can be completed in --days.....
QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....
QA->…..is given to environment friendly products of BIS (Bureau of Indian Standards)?....
QA->Decrease of viscosity with increasing shear rate is known as....
QA->In a two roll mill the shear rate is adjusted by....
MCQ->Working shear stress on the gross area of a rivet as recommended by Indian Standards, is....
MCQ->Gross flange area for a riveted plate girder is to be designed considering net area as 80% of its gross area. Consider width of the flange as 500 mm while web plate as 1000 mm x 12 mm. The girder is to resist a maxi-mum BM of 4500 kNm. Maximum allowable bending stress in tension is 150 MPa. Gross flange area is....
MCQ->Consider the following statements: 1. Bureau of Indian Standards was set up as a statutory organization under the Bureau of Indian Standards Act, 1986 2. Bureau of Indian Standards had taken over the assets and liabilities of the Indian Standards Institution (ISI) that came into existence in 1947. Which among the above statements is / are correct?....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
MCQ->The distance measured along one rivet line from the centre of a rivet to the centre of adjoining rivet on an adjacent parallel rivet line, is called....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution