Question Set

1. If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Water pipes break in winter in cold regions due to?....
QA->Find the maximum velocity for the overturn of a car moving on a circular track of radius 100 m. The co-efficient of friction between the road and tyre is 0.2?....
QA->In an examination of mathematics Rajesh obtained more marks than the total marks obtained by Rahim and Sabu. The total marks obtained by Rahim and Saji was more than the Rajesh’s. Rajesh obtained more marks than Saji, Reenu obtained more marks than Rajesh. Who amongst them obtained the....
QA->Substances that reduces friction are called?....
QA->A person climbing a hill bends forward inorder to?....
MCQ->If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as....
MCQ->If h is the loss due to friction in a pipe. Total losses in strainer and bends may be taken as....
MCQ->This question consists of a statement followed by two assumptions numbered I and II. An assumption is something supposed or taken for granted. You have to consider the statement and the following assumptions and decide which of those is/are implicit in the statement Statement : Bank B has requested the Apex Bank of the country to permit them to dilute Governments stake in the bank to raise funds from the equity market to balance the losses from non-performing assets. Assumption : I. The funds generated by diluting the Governments stake will enable the bank to recover from the losses to some extent. Assumption : II. Atleast some equity investors will be ready to purchase the shares of the bank.....
MCQ->Pressure drop due to pipe fittings can be estimated by the equation, , where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (dimensionless) for 45° elbow and 180° close return bends would be respectively around....
MCQ->Oil flows through a 200 mm diameter horizontal pipe with friction factor f=022 and length 500 m.The Volumetric flow rate is 2 m3S.The head loss due to friction in meters is(assume g=8 m/s2):....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution