Question Set

1. The cast iron pipes for water supply system are used for






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Water pipes break in winter in cold regions due to?....
QA->If the density of water is gcm- in C.G.S. System; what is its value in M.K.S. system?....
QA->If the density of water is gcm- in C.G.S. System, what is its value in M.K.S. system?....
QA->When an iron nail gets rusted, iron oxide is formed?....
QA->Which is the world's first film with a single actor in the star cast?....
MCQ->Consider the following statements : In water supply distribution network, 1. the grid-iron system requires more length of pipe lines and larger number of cut-off valves. 2. the design of the grid-iron system is difficult but economical. 3. employing a grid-iron system, the dead ends are completely eliminated. 4. employing a grid-iron system permits more water to be diverted towards the affected point from various directions. Which of the statements given above are correct ?....
MCQ->The cast iron pipes for water supply system are used for....
MCQ->Statement: In spite of less than normal rainfall in the catchment areas during the first two months of monsoon of the lakes supplying water to the city the authority has not yet affected any cut in the water supply to the city. Assumptions: The rainfall during the remaining part of the monsoon may be adequate for normal water supply. The present water level of the lakes supplying water to the city may be adequate for normal supply.

....
MCQ->The following steps are involved in making a spigot and socket joint of cast iron pipes used in water supply systems : 1. Tarred gasket or hemp yarn in wrapped around the spigot. 2. The sipgot end is centered into the socket end of the preceding pipe. 3. A joining ring end is placed around the barrel and against the face of the socket. 4. The gasket or hemp yarn in caulked slightly. 5. Molten pig lead is poured and then caulked. The correct sequence of these steps is....
MCQ->When cast-iron pipes are used to convey water with high pressure----------joints are used....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution