Question Set

1. The depth of the water table at a place is 45 m below the general ground level. To lift water from a deep tube well in such a locality, the type of pump to be installed is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->A simple pendulum is set up inside a lift. The period of oscillations is maximum when the lift is:?....
QA->The place in Kerala where rice is cultivated below sea level?....
QA->Megaloblast and Deficiency during pregnancy is associated with birth defects such as neural tube defects are due to the deficiency of?....
QA->All are of one Self-fraternity such being the dictum to avow, In such a light how can we take life And devoid of least pity go on to eat.who said?....
MCQ->The depth of the water table at a place is 45 m below the general ground level. To lift water from a deep tube well in such a locality, the type of pump to be installed is....
MCQ->To pump water from a water reservoir 3 m deep and maximum water level at 135 m, a pump is installed to lift water up to R.L. 175 m at a constant rate of 36, 00, 000 litres per hour. If the length of the pipe is 1506 m and f = 0.01, ignoring other minor losses and assuming the economical diameter from Lea's formula D = 1.2 Q , the water horse power of the pump is....
MCQ->A well penetrates to 30 m below the static water table. After 24 hours of pumping at 31.40 litres/minute, the water level in a test well at a distance of 80 m is lowered by 0.5 m and in a well 20 m away water is lowered by 1.0 m. The transmissibility of the auifer, is....
MCQ->For 3.25 x 10-2 cumecs discharging from a well, a pump is installed to lift water against a total head of 30 m. The minimum required horse power, is....
MCQ->Water is to be pumped at the rate of 0.025 m3/s from a 4 m deep ground level tank to an overhead tank. The difference in levels of the full tank levels of these tanks is 16 m. What is the approximate power required for operating a 65% efficient centrifugal pump ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution