Question Set

1. When an input electrical signal A=10100 is applied to a NOT gate, its output signal is






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->10100 എന്ന സംഖ്യയുടെ ഗണിതശാസ്ത്ര നാമം?....
QA->Which input device can not be used to work in MS - OFFICE ?....
QA->“Ask not, Say not, think not caste” are the words of?....
MCQ->When an input electrical signal A=10100 is applied to a NOT gate, its output signal is....
MCQ->An output gate is connected to four input gates; the circuit does not function. Preliminary tests with the DMM indicate that the power is applied; scope tests show that the primary input gate has a pulsing signal, while the interconnecting node has no signal. The four load gates are all on different ICs. Which instrument will best help isolate the problem?....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity to the input.....
MCQ->Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution