Question Set

1. Which of the following time will normally be determined by the requirements of the device to which the transfer is being made






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->An electronic device makes a beep after 60 sec.Another device makes a beep after ever 62sec.They beeped together at 10am.The time when they will next make a beep together at the earliest,is....
QA->Which device is used as the standard pointing device in a Graphical User Environment?....
QA->The length of an Earth day is determined by the time required for approximately one?....
QA->P takes twice as much time as Q or thrice as much time as R to finish a piece of work. They can finish the work in 2 days if work together. How much time will Q take to do the work alone?....
QA->Which of the following dose not represent on I/O device?....
MCQ->Which of the following time will normally be determined by the requirements of the device to which the transfer is being made....
MCQ->Consider the following statements An iron cored choke is a nonlinear device.A carbon resistor kept in a sunlight is a time - invariant and passive device.A dry cell is a time - varying and active device.An air capacitor is a time - invariant and passive device Of these statements....
MCQ->Consider the following statements An iron cored choke is non linear and passive device.A carbon resistor kept in sunlight is a time invariant and passive device.A dry cell is a time varying and active device.An air capacitor is time invariant and passive device. Of these statements....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
MCQ->The area of a plot is to be determined using Simpson's rule. The following offsets were taken to a boundary from points along a chain line all measurements being in metres 12, 15, 22, 29, 36, 38, 31, 22, 17.There were taken at 100 m intervals. Consider the following steps in this regard. 1. 2. Sum of the odd ordinates = 22 + 36 + 1 = 89 3. Sum of the even ordinates = 15 + 29 + 38 + 22 = 104 4. 12 + 17 = 39 5. Area = 100 (19.5 + 89 + 104) 6. Area = (39 + 2 x 89 + 4 x 104) 7. Area 100 x 19.5 (104 - 89) The area of the plot can be determined by using the steps listed above :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution