Question Set

1. Using the _____ switch causes FDISK to display the partition status of your hard disk without executing FDISK.






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The activity of creating sectors and tracks on a hard disk is called....
QA->Method of cultivating plants without using soil but by using nutrient solution?....
QA->Mycobacterium leprae causes leprosy; Corynebacterium diphtheria causes diphtheria and Vibrio comma causes?....
QA->Where in your body is your patella?....
QA->Where in your body is your patella....
MCQ->Using the _____ switch causes FDISK to display the partition status of your hard disk without executing FDISK.....
MCQ->You install your boot volume on volume C on your Windows 2000 Server computer. You mirror volume C on dynamic Disk 1. Two years later, during routine server maintenance, you open Disk Management and find that the status of volume C is Failed Redundancy. The status of Disk 1 is Missing. You attempt to reactivate Disk 1, but the status of volume C does not return to Healthy. What should you do next?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->You are the administrator of Windows 2000 Server computer. Your computer has a span volume that consists of areas on three physical hard disks on the server. The three disks support hot swapping. You regularly backup the span volume by using windows backup. One of the disk fail, you replace the disk with a new un-partitioned disk. You want to recover the span volume and disk data as soon as possible. What should you do?....
MCQ->Your Windows 2000 Server computer contains a stripe set with parity on a four-disk array. You convert the stripe set with parity to a dynamic RAID-5 volume. Six months later, users report that disk access on the server is slower than it had been on the previous day, You use Disk Management and discover that the status of the third disk in the array is Missing. You want to recover the failed RAID-5 volume. What should you do first?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution