Question Set

1. After coding a document into a digital signal, it can be sent by telephone, telex or satellite to the receiver where the signal is decoded and an exact copy of the original document is made. What is it called?






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->In a coding system PEN is written as NZO and BARK as CTSL. How can we write PRANK in that coding system ?....
QA->P can do a work in 24 days. Q can do the same work in 9 days and R can do the same in 12 days. Q and R start the work and leave after 3 days. P finishes the remaining work in --- days.....
QA->P and Q can do a work in 30 days. Q and R can do the same work in 24 days and R and P in 20 days. They started the work together, but Q and R left after 10 days. How many days more will P take to finish the work?....
QA->.....is a device by virtue of which two persons at two different places can communicate. It consists of two main parts (i) a microphone and (ii) a receiver.?....
MCQ->After coding a document into a digital signal, it can be sent by telephone, telex or satellite to the receiver where the signal is decoded and an exact copy of the original document is made. What is it called?....
MCQ->Messages from one computer terminal can be sent to another by using data networks. The message to be sent is converted to an electronic digital signal, transmitted via a cable, telephone or satellite and then converted back again at the receiving end. What is this system of sending messages called?....
MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....
MCQ->Consider the following statements: In the case of space wave propagation, the signal strength at the receiver is Directly proportional to transmitter and receiver heights.Inversely proportional to distance between transmitter and receiver.Directly proportional to frequency. Which of the above statements is/are correct?....
MCQ->Computers cannot communicate with each other directly over telephone lines because they use digital pulses whereas telephone lines use analog sound frequencies. What is the name of the device which permits digital to analog conversion at the start of a long distance transmission?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution