Question Set

1. In oxy-acetylene gas welding the volume of oxygen required per unit volume of oxygen required per unit volume of acetylene:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The spatial frequency of a wave, either in cycles per unit distance or radians per unit distance is called?....
QA->Which gases are used for gas welding?....
QA->As per the revised Goods and Services Tax (GST) norms, the GST on Haj and Kailash Mansarovar Yatra has been reduced from 18 per cent to how much per cent?....
QA->The mass per unit volume of a substance is known as its?....
QA->Which chamber of human heart pumps fully oxy; genated blood to aorta and hence to the body?....
MCQ->In oxy-acetylene gas welding the volume of oxygen required per unit volume of oxygen required per unit volume of acetylene:....
MCQ->Theoretical volume of oxygen required for complete combustion of 1Nm3 of acetylene, in oxy-acetylene welding is __________ Nm3 .....
MCQ->In a gas welding of mild steel using an oxy-acetylene flame, the total amount of acetylene consumed is 10 litre. The oxygen consumption from the cylinder is....
MCQ->If neutral flame is used in oxy-acetylene welding, both oxygen and acetylene cylinders of the same capacity will be emptied at the same time.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution