Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
Name the type that are cast blocks of metal that are kept in the top shelf of the wooden case is called ?->(Show Answer!)
Question Set

1. Name the type that are cast blocks of metal that are kept in the top shelf of the wooden case is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Name the type that are cast blocks of metal that are kept in the top shelf of the wooden case is called....
QA->Who said ‘Climbing to the top demands strength; whether it is to the top of Mount Everest or to the top of your career’?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Name the section at the top of the document used to place the name, page number etc.,:....
MCQ->Name the type that are cast blocks of metal that are kept in the top shelf of the wooden case is called....
MCQ->What will be the output of the C#.NET code snippet given below? char ch = Convert.ToChar ('a' | 'b' | 'c'); switch (ch) { case 'A': case 'a': Console.WriteLine ("case A | case a"); break; case 'B': case 'b': Console.WriteLine ("case B | case b"); break; case 'C': case 'c': case 'D': case 'd': Console.WriteLine ("case D | case d"); break; }....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->If two blocks of equal mass are attached to the two ends of a light string and one of the blocks is placed over a smooth horizontal plane while the other is hung freely after passing over a smooth pulley, then the two blocks will have some motion.....
MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution