Question Set

1. A principle regarding most display decoders is that when the correct input is present, the related output will switch:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Use the correct adverb to replace the group of words in bold letters. He was appointed Principle, FOR THE PRESENT TIME ONLY”:....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->Most common input device used today is ?....
QA->Which Article of the Constitution is related to the protection of certain rights regarding freedom of speech?....
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
MCQ->Consider the following statements A 4 : 16 decoder can be constructed (with enable i/p) by Using four 2 : 4 decoders (each with an enable i/p) onlyUsing five 2 : 4 decoders (each with an enable i/p) onlyUsing two 3 : 8 decoders (each with an enable i/p) onlyUsing two 3 : 8 decoders (each with an enable i/p) only Which of the statements given above is/are correct?....
MCQ->A principle regarding most display decoders is that when the correct input is present, the related output will switch:....
MCQ->A principle regarding most IC decoders is that when the correct input is present, the related output will switch:....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution