1. The term race condition describes the time that an active signal must be present at the input to a flip-flop before an active clock edge is applied.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->Time in the reflection of a clock is 10 pm, then what is the original time?....
QA->Majority of modem Human race' belonged to which race ?....
QA->Which is the first boat race in Kerala which marks the beginning of the season of boat race in Kerala?....
MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....
MCQ->The term race condition describes the time that an active signal must be present at the input to a flip-flop before an active clock edge is applied.....
MCQ->Consider the following statements: Race around condition can occur in JK flip flop when both inputs are 1A flip flop is used to store one bit of informationA transparent latch is a D type flip flopMaster slave flip flop is used to store two bits of information Which of the above are correct?....
MCQ->Consider the following statements: A flip-flop is used to store 1-bit of information. Race-around condition occurs in a J-K flip-flop when both the inputs are 1. Master-slave configuration is used in flip-flops to store 2-bits of information A transparent latch consists of a D-type flip-flop. Which of the above statements is/are correct?....
MCQ->When using edge-triggered flip-flops, the data is entered into the flip-flop on the leading edge of the clock, but the output does not change until the trailing edge of the clock.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution