Question Set

1. The AND is the simplest of the gates, requiring the least amount of circuitry to implement in TTL.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->On July 11, 2017, which country hosted a major international summit on family planning, in partnership with UN Population Fund (UNFPA) and the Bill and Melinda Gates Foundation?....
QA->The first state in India to implement Land reforms Bill and Education Reforms Bill?....
QA->Which is the tree requiring minimum water for its growth?....
QA->Who was conferred with the "Global Goalkeeper" award by the Bill and Melinda Gates Foundation on September 24, 2019 for his leadership in India’s massive Swachh Bharat Abhiyan?....
QA->Name the activist who has become the first Indian to be awarded the Changemaker Award 2019 by the Bill and Melinda Gates Foundation for her work towards abolition of child marriage in Rajasthan?....
MCQ->The AND is the simplest of the gates, requiring the least amount of circuitry to implement in TTL.....
MCQ->Which two can be used to create a new Thread? Extend java.lang.Thread and override the run() method. Extend java.lang.Runnable and override the start() method. Implement java.lang.Thread and implement the run() method. Implement java.lang.Runnable and implement the run() method. Implement java.lang.Thread and implement the start() method.....
MCQ->Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect themReason (R): VOH, VOL, VIH and VIL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. VIL and VIH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.

....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Which of the following can be facilitated by the Inheritance mechanism? Use the existing functionality of base class. Overrride the existing functionality of base class. Implement new functionality in the derived class. Implement polymorphic behaviour. Implement containership.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution