Question Set

1. The 8051 is a 40-pin IC. Twenty-two pins are needed for the four I/O ports.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Twenty - Twenty vision means?....
QA->PIN number എന്നതിൽ PIN ന്റെ പൂർണരൂപം....
QA->Sankaracharya founded four mutts in four comers of India;They are?....
QA->Who founded four mathas in the four comers of India?....
QA->A word is given in capital letters. It is followed by four words. Out of these four words, three cannot be formed from the letters of the word in capital letters. Point out the word which can be formed from the letters of the given word in capital letters— ARCHITECTURE....
MCQ->The 8051 is a 40-pin IC. Twenty-two pins are needed for the four I/O ports.....
MCQ->These include taper pins, straight pins, dowel pins, clevis pins, and cotter pins:....
MCQ->Statements: Some pins are needles. All needles ae swords. Some swords are knives. Conclusions : I. All swords being pins is a possibility. II. No neele being knife is a possibility. (1) Only Conclusion I follows (2) Only Conclusion II follows (3) Either Conclusion I or Conclusion II follows (4) Neither Conclusion I nor Conclusion II follows (5) There is possibility that some pins are knives.....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->Consider the following statements about hybrid ring Ports 1 and 2 are decoupled.Port 3 and 4 are coupled.A signal entering either port 1 or 2 splits equally between ports 3 and 4.A signal entering either port 3 or 4 splits equally between ports 1 and 2. Which of the above are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution