Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
As per Indian standards,only-------------welding shall be done for all joints in stainless steel for construction of a milk silo ?->(Show Answer!)
Question Set

1. As per Indian standards,only-------------welding shall be done for all joints in stainless steel for construction of a milk silo





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->In a mixture of 35 litres, the ratio of milk and water is 5 : Another 5 litres of milk is added to the mixture. The ratio of milk and water in the new mixture is—....
QA->Who is the inventor of Steel (Stainless)?....
QA->Stainless steel is an alloy of which metals?....
QA->“The state shall have no religion of its own and all persons shall be equally entilted to freedom of conscience and right freely to profess, practice and propagate religion”- This principle is termed?....
MCQ->As per Indian standards,only-------------welding shall be done for all joints in stainless steel for construction of a milk silo....
MCQ->Consider the following statements: 1. Bureau of Indian Standards was set up as a statutory organization under the Bureau of Indian Standards Act, 1986 2. Bureau of Indian Standards had taken over the assets and liabilities of the Indian Standards Institution (ISI) that came into existence in 1947. Which among the above statements is / are correct?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A milk vendor has 2 cans of milk. The first contains 25% water and the rest milk. The second contains 50% water. How much milk should he mix from each of the containers so as to get 12 litres of milk such that the ratio of water to milk is 3 : 5?....
MCQ->In a welding drawing, joints are all shown as they would appear before welding.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution