Question Set

1. A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->What minimum number of non-zero non-collinear vectors is required to produce a zero vector?....
QA->The minimum number of non-zero non-collinear vectors required to produce a zero vector is?....
QA->The average of 20 numbers is zero. Of them , at the most ,how many may be greater than zero?....
MCQ->A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is....
MCQ->The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is....
MCQ->A band-pass filter can be created by cascading a high-pass filter and a low-pass filter.....
MCQ->Assertion (A): Peak to peak value of a sinusoidal wave is 2.828 times the rms value.Reason (R): Peak factor of a sinusoidal wave is 1.414.

....
MCQ->A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution