Question Set

1. For a common-emitter amplifier, the purpose of swamping is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.The common purpose of the over running clutch in the starter drive is to:....
QA->Which sector is the largest emitter of greenhouse gases in India?....
QA->Which sector is the largest emitter of greenhouse gases in India ?....
QA->According to Greenpeace data which country is the largest emitter of anthropogenic sulphur dioxide (SO2) which is produced from burning of coal and greatly contributes to air pollution?....
QA->One who is devoted to books only for learning facts just for the purpose of scoring marks is called a?....
MCQ->For a common-emitter amplifier, the purpose of swamping is....
MCQ->In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be....
MCQ->If a common emitter amplifier with an emitter resistance RC has an overall transconductance gain of 1 m A/V, a voltage gain of - 4 and desensitivity of 50, then the value of the emitter resistance R would be....
MCQ->For a common-emitter amplifier, the purpose of the emitter bypass capacitor is....
MCQ->Match the following: List I List II A.Total instantaneous value of emitter current1.IEB.Quiescent value of emitter current2.iEC.Instantaneous value of as component of emitter current3.IeD.RMS value of ac component of emitter current4.ie

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution