Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in database-database-redesign
Multiple Choice Question in 035/2016
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
electronic devices bjt amplifiers
1. For transistor amplifiers, the no-load voltage gain is ________ the loaded voltage gain.
(A): greater than
(B): None of the above
(C): smaller than
(D): the same as
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->Who is the inventor of Transistor?....
QA->Three regions of a transistor?....
QA->Transistor transfers a signal from a low resistance to?....
QA->Transistor was invented by?....
MCQ->For transistor amplifiers, the no-load voltage gain is ________ the loaded voltage gain.....
MCQ->A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a resistance of 10 . If the load resistance decreases to 7.5 , the load voltage will decrease to 10.9 V. The load current will be ________, and the percent load regulation is ________.....
MCQ->A common-emitter amplifier has ________ voltage gain, ________ current gain, ________ power gain, and ________ input impedance.....
MCQ->Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution