Question Set

1. For an op-amp having a slew rate SR = 5 V/ms, what is the maximum closed-loop voltage gain that can be used when the input signal varies by 0.2 V in 10 ms?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->Which input device can not be used to work in MS - OFFICE ?....
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->At his usual rowing rate, Ram can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
MCQ->For an op-amp having a slew rate SR = 5 V/ms, what is the maximum closed-loop voltage gain that can be used when the input signal varies by 0.2 V in 10 ms?....
MCQ->Which of the following sentences are correct about a for loop in a C program? 1: for loop works faster than a while loop. 2: All things that can be done using a for loop can also be done using a while loop. 3: for(;;); implements an infinite loop. 4: for loop can be used if we want statements in a loop get executed at least once.....
MCQ->Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & operator can be used to check whether a bit is ON. The & operator can be used to check whether a bit is OFF.....
MCQ->Assertion (A): A sine wave with slew rate distortion looks rectangularReason (R): The maximum rate of output voltage change is called slew rate

....
MCQ->The midrange open-loop gain of an op-amp is 135 dB. With negative feedback this gain is reduced to 72 dB. The closed-loop gain is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution