Question Set

1. Refer to this figure. This circuit is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->By whom was word Adivasi was used for the first time to refer to the tribal people?....
QA->Of which allocation does Gadgil Formula refer to?....
QA->To whom the 'Yavanas' refer?....
MCQ->Which two statements are true about wrapper or String classes? If x and y refer to instances of different wrapper classes, then the fragment x.equals(y) will cause a compiler failure. If x and y refer to instances of different wrapper classes, then x == y can sometimes be true. If x and y are String references and if x.equals(y) is true, then x == y is true. If x, y, and z refer to instances of wrapper classes and x.equals(y) is true, and y.equals(z) is true, then z.equals(x) will always be true. If x and y are String references and x == y is true, then y.equals(x) will be true.....
MCQ->Statement: "You must learn to refer to dictionary if you want to become a good writer." - A advises B. Assumptions: Only writers refer to the dictionary. All writers, good or bad, refer to the dictionary.

....
MCQ->Refer to the given figures (a) and (b). A logic analyzer is used to check the circuit in figure (a) and displays the waveforms shown in figure (b). The actual analyzer display shows all four data outputs, Q0-Q3. The analyzer's cursor is placed at position X and all four of the data output lines show a LOW level output. What is wrong, if anything, with the circuit?

....
MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....
MCQ->Refer to the keyboard encoder in figure (a). Sometimes when the 5 key is pressed, the system attached to the keypad does not respond. The 5 input on the 74147 is monitored with a digital storage scope while repeatedly pressing the 5 key, and the waveform in figure (b) is obtained; the P above the trace indicates the points at which the technician pressed the key. What is most likely wrong with the circuit?

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution