Question Set

1. What kind of diode is formed by joining a doped semiconductor region with a metal?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The process by which water diffuses through a semi-permeable membrane from a region of higher concentration of a solution to a region of lower concentration of a solution?....
QA->The Ruhr-Westphalia region is a famous industrial region of which country?....
QA->Transfer of heat from hotter region carrying heat to a colder region is called?....
QA->The movement of particles or molecules of a substance from the region of higher concentration to a region of lower concentration is called ........?....
MCQ->What kind of diode is formed by joining a doped semiconductor region with a metal?....
MCQ->Consider the following statements about conditions that make a metal semiconductor contact rectifying N type semiconductor with work function φs more than work function φM of metalN type semiconductor with work function φs less than work function φM of metalP type semiconductor with work function φs more than work function φM of metalP type semiconductor with work function φs less than work function φM of metal. Of these statements....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The p-n junction of a tunnel diode is doped at a level from ________ to ________ times that of a typical semiconductor diode.....
MCQ->Consider the following statements Impedance of Gunn diode is about tens of ohms.Impedance of Impatt diode is a few ohms.Impedance of Impatt diode are of the same order.Impedance of Impatt diode is more than that of Gunn diode. Which of the above statement are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution