Question Set

1. In an averaging amplifier, the input resistances are





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.....is used for comparing the e.m.f.s, of cells, measurements of the thermal e.m.f.s, large potential differences and currents. It is also used for measuring low resistances.?....
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->കംപ്യൂട്ടർ പ്രൊസസിങ് നടക്കുന്നതിന് മുൻപ് Input Dataയിൽ മാറ്റം വരുത്തുന്നത്.....
QA->Which of the following groups consists of only input devices?....
QA->Most common input device used today is ?....
MCQ->In an averaging amplifier, the input resistances are....
MCQ->If the value of resistor Rf in an averaging amplifier circuit is equal to the value of one input resistor divided by the number of inputs, the output will be equal to....
MCQ->An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution