Power supplies are regulated to prevent the output voltage from changing due to changes in the ?->(Show Answer!)

Question Set

1. Power supplies are regulated to prevent the output voltage from changing due to changes in the

Show Similar Question And Answers

QA->The device used for converting current from a lower voltage to a higher voltage is known as?....

QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....

QA->The production of ail electromotive force (voltage) across an electrical conductor due to its dynamic interaction with a magnetic field is called?....

QA->Which type of forest belt supplies most of the world’s requirement of newsprint?....

QA->The headquarters of Kerala Civil Supplies Corporation?....

MCQ->Power supplies are regulated to prevent the output voltage from changing due to changes in the....

MCQ->The Switched Mode Power Supplies have higher energy efficiency compared to Linear Power Supplies because:....

MCQ->Governments may have to take steps which would otherwise be an infringement on the Fundamental Rights of individuals, such as acquiring a person's land against his will, or refusing permission for putting up a building, but the larger public interest for which these are done must be authorized by the people (Parliament). Discretionary powers to the administration can be done away with. It is becoming more and more difficult to keep this power within limits as the government has many number of tasks to perform. Where discretion has to be used, there must be rules and safeguards to prevent misuse of that power. Systems have to be devised which minimise, if not prevent, the abuse of discretionary power. Government work must be conducted within a framework of recognised rules and principles, and decisions should be similar and predictable. Which among the following is the most logical assumption that can be made from the above passage?....

MCQ->Refer to the display multiplexer given below. The MSD display is blank, while the LSD seems to be OK. The input and output lines to the 74157 and 7449 are checked with a scope and can be seen changing levels. The A input on the 74139 also changes; however, the 0 output on the 74139 is always LOW and the 1 output is always HIGH. The B and EN inputs on the 74139 are always LOW. What could cause the problem and what should be done to correct it?

MCQ->In a voltage regulated power supply the zener operates in the breakdown region when (Vin is input voltage and Vz is zener breakdown voltage)....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution