Question Set

1. With 20 V applied, an 8-ohm resistor is in series with a lamp. When the lamp is removed, what voltage will be read across the lamp socket?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->There are 4000 literates in a village.45 % read Newspaper A and 65% read Newspaper B.25% read neither A nor B.How many persons read both the newspapers?....
QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....
QA->Old-written material; which cannot be read easily; how can be read?....
QA->Old-written material, which cannot be read easily, how can be read?....
MCQ->With 20 V applied, an 8-ohm resistor is in series with a lamp. When the lamp is removed, what voltage will be read across the lamp socket?....
MCQ->A 3-ohm resistor is connected is parallel to 6-ohm resistor.The combination is connected in series to an 8-ohm resistor.A 10-ohm resistor is connected in parallel to the whole combination.The effective resistance is:....
MCQ->Two resistors are in series: a 5.6 k resistor and a 4.7 k resistor. The voltage drop across the 5.6 k resistor is 10 V. The voltage across the 4.7 k resistor is....
MCQ->The parallel combination of a 6.8 k resistor and a 10 k resistor is in series with the parallel combination of a 2.2 k resistor and a 1 k resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)....
MCQ->The following steps are involved in making a spigot and socket joint of cast iron pipes used in water supply systems : 1. Tarred gasket or hemp yarn in wrapped around the spigot. 2. The sipgot end is centered into the socket end of the preceding pipe. 3. A joining ring end is placed around the barrel and against the face of the socket. 4. The gasket or hemp yarn in caulked slightly. 5. Molten pig lead is poured and then caulked. The correct sequence of these steps is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution