Question Set

1. The voltage out when a 10 k load is connected is 5.7 volts.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->Out and out....
QA->Name the Operation carried out by Army to flush out six terrorist at Pathankot ( പാത്തന് ‍ ക്കോട്ട് ) airbase recently...?....
QA->A word given in Capital Letters is followed by four answer words. Out of these only one can be formed by using the letters of the given words. Find out that word— ENVIRONMENT....
MCQ->A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a resistance of 10 . If the load resistance decreases to 7.5 , the load voltage will decrease to 10.9 V. The load current will be ________, and the percent load regulation is ________.....
MCQ->The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts, is ....
MCQ->A three phase balanced delta connected of 5+j6 Ohm in each phase is connected to a line voltage of 400V is drawing current from the supply.If anoter delta connected load of same nature and magnitude is connected in parallel,the line current drawn from the supply becomes:....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution