1. In order to get a HIGH or a LOW output from an open-collector gate, an external _________ must be connected between +VCC and the collector.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a stay order has been granted by the High Court in a case, the application of the affected party by such an order shall be disposed of by the High Court within a period of?....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->At 8 o’ clock in the morning Mr.Ram was at a distance of 105 km from the railway station. To get his train was to reach the station at least at 45 a.m. The minimum speed required for him to travel in order to get the train is :....
QA->A, B, C, D, E and F are sitting in six chairs regularly placed around a round table. It is observed that A is between D and F, C is opposite to D, D and E are not on neighboring chairs. Which one of the following must be true ?....
MCQ->In order to get a HIGH or a LOW output from an open-collector gate, an external _________ must be connected between +VCC and the collector.....
MCQ->Read the following statements as regards register pairs in microprocessor 8085B represents B, C pair with B as high order register and C as low order register.D represents D, E pair with D as high order register and E as low order register.H represents H, L pair with H as high order register and L as low order register. Which of the above statements are correct?....
MCQ->A certain gate draws 1.8 A when its output is HIGH and 3.3 µA when its output is LOW. VCC is 5 V and the gate is operated on a 50% duty cycle. What is the average power dissipation (PD)?....
MCQ->An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution