Question Set

1. If N bits are lumped together to get an N-bit symbol, the possible number of symbols is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 11.48 pm
    Each bit can have two levels. Hence 2N.
Show Similar Question And Answers
QA->In computing there are 8 bits to a byte, what are 4 bits called?....
QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....
QA->“It is possible to fail in many ways; while to succeed is possible only in one way”?....
QA->The scientist who gave symbols for elements on the basis of their names?....
QA->When a number’x’is divided by’4’ we get the cube of another number y.Find x if y(Cube)<10....
MCQ->If N bits are lumped together to get an N-bit symbol, the possible number of symbols is....
MCQ->A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as....
MCQ->Consider the following statements as regards BPSK and QPSK: In BPSK we deal individually with each bit of duration TbIn QPSK we lump two bits to form a symbolIn both BPSK and QPSK signal changes occur at bit rateIn QPSK the symbol can have any one of four possible values Which of the above statements are correct?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In how many days can B alone complete the work A,B, and C together can complete the work in 4 32/37 days. A and B together can complete the work in 6 2/3 days, B and C together can complete the work together in 8 2/11 days and A and C together can complete the work in 7 1/3 days.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution