Question Set

1. A remote control for TV uses





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 01 Jun 2017 11.49 pm
    Infrared LED transmits the pulse. At receiver photo diode converts infrared signals into electrical signals.
Show Similar Question And Answers
QA->What does TV remote control unit use to operate a TV set?....
QA->The real control of the Indian Government was passed into the hands of the President of Board of Control by passing the?....
QA->Which of the following is not a quantitative credit control weapon used by RBI to control credit....
QA->Recurrence of some disease after generation or similarity in special features with remote ancestors....
QA->National Remote Sensing Agency is located in?....
MCQ->You want to provide Internet access for the clients on your network. You decide to use Network Address Translation (NAT). You have a Windows 2000 computer you try to establish a secure Virtual Private Networking session with. You try connecting to the Remote Windows 2000 computer using L2TP. You are unable to establish a connection with the remote node using L2TP. You are able to make a connection with another computer in your same office. Why are you unable to make a connection.to the remote location?....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->The Acme Corporation is implementing dial-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols, needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services?....
MCQ->Which of the following statements are correct? The switch statement is a control statement that handles multiple selections and enumerations by passing control to one of the case statements within its body. The goto statement passes control to the next iteration of the enclosing iteration statement in which it appears. Branching is performed using jump statements which cause an immediate transfer of the program control. A common use of continue is to transfer control to a specific switch-case label or the default label in a switch statement. The do statement executes a statement or a block of statements enclosed in {} repeatedly until a specified expression evaluates to false.....
MCQ->Consider the following statements about 8085 The instruction LDA uses direct addressing mode.The instruction MVI uses direct addressing mode.The instruction MVI uses immediate addressing mode.The instruction LDA uses immediate addressing mode. Which of the above are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution