Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് മേയ് 11
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് - ഏപ്രില് 07
Multiple Choice Question in current-affairs-2016-12-22
Multiple Choice Question in current-affairs-2017-01-22
Multiple Choice Question in biochemistry-structure-and-properties-of-peptides
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് - ക്വിസ് | ഡിസംബര് 05 - 12
Multiple Choice Question in biochemical-engineering-fluid-flow
Multiple Choice Question in biochemistry-allosteric-effects
Multiple Choice Question in current-affairs-2017-05-07
Multiple Choice Question in കറന്റ് അഫയേഴ്സ് മേയ് 26
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
electronics and communication engineering digital electronics
1. What will be output for decimal input 82?
(A): 0.1 V
(B): 0.82 V
(C): 10 mV
(D): 8 V
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
By: guest on 01 Jun 2017 11.53 pm
Output for decimal input 82/(10000010) = 0.01 x 82 = 0.82 V.
Show Similar Question And Answers
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->The output quality of printer is measured by..........
QA->Which one of the following is an output device?....
QA->. In a normal person at rest the cardiac output or amount of blood pumped per minute by the left ventricle is approximately—....
QA->കംപ്യൂട്ടർ പ്രൊസസിങ് നടക്കുന്നതിന് മുൻപ് Input Dataയിൽ മാറ്റം വരുത്തുന്നത്.....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.....
MCQ->If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity to the input.....
MCQ->Refer to the display multiplexer given below. The MSD display is blank, while the LSD seems to be OK. The input and output lines to the 74157 and 7449 are checked with a scope and can be seen changing levels. The A input on the 74139 also changes; however, the 0 output on the 74139 is always LOW and the 1 output is always HIGH. The B and EN inputs on the 74139 are always LOW. What could cause the problem and what should be done to correct it? ....
MCQ->If one input to a 2-input AND gate is HIGH, the output reflects the other input.....
MCQ->In a common-base configuration, the input and output voltages are ________ and the output and input currents are ________.....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution